|
|
Start of CV1800 Install back in March of 2007
Date: 03/01/2007
Views: 537
|
|
Date: 03/01/2007
Views: 384
|
|
Motor Installed up in rafters
Date: 04/11/2007
Views: 355
|
|
Initial relay control box and motor plug receptacle location and wiring.
Date: 03/10/2007
Views: 329
|
|
|
Modified relay control box and motor plug receptacle with remote added in 2009.
Date: 10/17/2009
Views: 343
|
|
Start of ducting as it penetrates the drop cieling and rafter area
Date: 04/11/2007
Views: 322
|
|
View looking back at the start of the main ducting run in overhead.
Date: 04/11/2007
Views: 337
|
|
Main run alternate view 1
Date: 04/11/2007
Views: 303
|
|
|
Main run alternate view 2
Date: 04/11/2007
Views: 314
|
|
View looking to end of the run to the far wall
Date: 04/11/2007
Views: 301
|
|
Far wall ducting drop through ceiling area
Date: 04/11/2007
Views: 331
|
|
Drop at far end back into the shop made with a 45 and flex
Date: 04/11/2007
Views: 320
|
|
|
Far side main drop from flex of previous photo
Date: 09/06/2008
Views: 370
|
|
Homemade floor sweep
Date: 09/02/2008
Views: 365
|
|
Belt sander feed is 6" duction directly into bottom.
Date: 09/02/2008
Views: 337
|
|
Belt sander with interface box painted.
Date: 09/06/2008
Views: 317
|
|
|
Closeup of belt sander interface box before painting
Date: 09/02/2008
Views: 303
|
|
Start of the tablesaw ducting run.
Date: 09/06/2008
Views: 347
|
|
Close up of the tablesaw ducting split.
Date: 09/06/2008
Views: 354
|
|
Tablesaw runs finished in flex to allow some movement in the shop
Date: 09/06/2008
Views: 375
|
|
|
Table saw bottom port closeup
Date: 09/06/2008
Views: 357
|
|
View of top port attached to a modified Delta Blade Guard
Date: 09/06/2008
Views: 384
|
|
Tablesaw with the new Shark Guard with a 4 inch flex hose and series gate
Date: 06/27/2009
Views: 428
|
|
Altenate view of Shark Guard
Date: 06/27/2009
Views: 380
|
