|
|
08-21-09_1902
Shop under construction. Showing branch lines with drops. From left to right: RAS/Miter, Floor sweep, Jointer, Floor sweep. Used ASTM 2729. Worked great, do not use glue! There is a good seal without it.
Date: 08/21/2009
Views: 722
|
|
08-21-09_1903
Panoramic. You can see other drops not in first picture.
Date: 08/21/2009
Views: 624
|
|
08-21-09_1904
I added a partition wall in my shop. The 2 openings will be sliding doors. The cyclone and filter assembly are on the other side of the partition. The HVAC flex is approx 19' long. It did help with noise, which is no longer bothersome at all.
Date: 08/21/2009
Views: 732
|
|
08-21-09_1905
closer picture of cyclone. Ceilings are approx 13'6" tall.
Date: 08/21/2009
Views: 668
|
|
|
08-21-09_1906
Candelabra bulb. Used 1/4" Plexiglas for window.
Date: 08/21/2009
Views: 628
|
|
08-21-09_1907
Photo eye. Works great, but there is a delay at both start-up and shut down of about 25 seconds. May do something with start-up delay, but not sure if it will be a problem yet.
Date: 08/21/2009
Views: 567
|
|
08-21-09_1908
Filters.
Date: 08/21/2009
Views: 605
|
|
08-21-09_1909
Close up of clean-out. Again used ASTM 2729/3434 fittings. This is a short piece of 4" 2729 with a 90 deg, then a screw in plug. The assembly is screwed into a 3/4" round that bolts to bottom of filters. All was caulked, except the elbow. There
Date: 08/21/2009
Views: 558
|
