|
|
IMG_1586
Back of radial arm saw after mounting brackets for dust collector hood. The saw is on a wheeled cabinet with a wooden spacer between the two.
Date: 06/29/2008
Views: 557
|
|
IMG_1587
Side view of RAS with bracket for dust hood.
Date: 06/29/2008
Views: 467
|
|
IMG_1590
Extension table for RAS. This will support the dust hood and ductwork.
Date: 06/29/2008
Views: 357
|
|
|
IMG_1597
Test fit of the custom duct.
Date: 06/30/2008
Views: 401
|
|
IMG_1599
Another dry fit picture. View of the back.
Date: 06/30/2008
Views: 375
|
|
IMG_1600
Tunnel vision.
Date: 06/30/2008
Views: 401
|
|
|
IMG_1602
Glued and pinned with a brad nailer.
Date: 06/30/2008
Views: 385
|
|
IMG_1603
Ready to install the new duct.
Date: 06/30/2008
Views: 379
|
|
IMG_1605
Looking up into the tunnel. You can see the gap for the dust. The extension table is supported by a screw and fender washer.
Date: 06/30/2008
Views: 353
|
|
|
IMG_1607
Back view with tunnel mounted. Assembly started on the hood. No plans to permanently mount the hood to the table, Gravity and friction should hold it in place. The sides and back are also "keyed" to lock it in place on the table.
Date: 06/30/2008
Views: 359
|
|
IMG_1609
Side view of dust hood during assembly.
Date: 06/30/2008
Views: 356
|
|
IMG_1610
Looking into the hood. I still need to build a top and angled deflector. I also need a custom 90 deg. sweep. I will use the sweep on the cyclone as inspiration.
Date: 06/30/2008
Views: 368
|
|
|
IMG_1620
New sweep for RAS. Made of 3/4" MDF and some white aluminum flashing. I have lots of flashing left over from the construction of my shop.
Date: 07/04/2008
Views: 341
|
|
IMG_1622
Sweep installed
Date: 07/04/2008
Views: 330
|
|
IMG_1623
view with duct exposed.
Date: 07/04/2008
Views: 341
|
|
|
IMG_1624
table extension installed
Date: 07/04/2008
Views: 335
|
|
IMG_1625
Table reinstalled after rounding over the slot edge with 1/2" roundover bit (seen in the back).
Date: 07/04/2008
Views: 325
|
|
IMG_1612
Time for a cookout! I need a custom transition from 5 1/2" square to 6" round. Starting with 10" of 6" PVC S&D pipe.
Date: 07/04/2008
Views: 377
|
