|
|
CIMG0044
Finished Mini Cabinet
Date: 11/15/2008
Views: 443
|
|
CIMG0035
Base Cabinet, Hole in top for Shop Vac and hole in shelf for bottom of CV mini
Date: 11/15/2008
Views: 271
|
|
CIMG0037
Standard Metal Trash Can with Electrical Conduit Coupling. Trash can lid is sealed with foam for air tight seal,
Date: 11/15/2008
Views: 299
|
|
CIMG0044
Here you can see the full cabinet. Hole was drilled in the bottom of Shop Vac. A short flex hose goes from bottom of the shelf into the can. All parts are friction fit for easy removal.
Date: 11/15/2008
Views: 363
|
|
|
CIMG0040
This is where the vac sits. Electrical conduit fits snugly into the bottom of the vac. I had to sand off the bottom of the piece to fit into the top of the mini. Wrap with electrical tape for better seal
Date: 11/15/2008
Views: 297
|
|
CIMG0039
On the bottom of the Mini I put concentric circles of foam. It is held in place with small wedges on the top. The wheels of the new vac were used on the bottom of the cabinet. Cabinet was built from 3/4 ply.
Date: 11/15/2008
Views: 356
|
|
CIMG0048
Extra space beside the CV holds extra hoses and nozzles
Date: 11/15/2008
Views: 377
|
|
CIMG0042
Hole drilled in bottom of vac with 2" hole saw, use standard electrical coupling sealed with silicone.
Date: 11/15/2008
Views: 285
|
|
|
CIMG0043
Be sure to seal under the lid of the shop vac.
Date: 11/15/2008
Views: 291
|
|
CIMG0046
Home made down draft table using old furnace fan and 3 speed motor. Inside are two sets of 3M filters. This pulls out most of the airborne dust is used as a sanding table and out feed table for the table saw. Just google down draft table for several pla
Date: 11/15/2008
Views: 344
|
|
|
